When installing Windows XP, the blue screen is a verdict or a little trouble?
Watching when installing Windows XP blue screen,it is recommended not to make one more attempt, but to analyze what is happening. It is necessary to remember what messages preceded its appearance (sometimes they are displayed, but users-beginners press "Ok" without even reading).In general, after seeing the installation of Windows bluescreen, do not panic. If the computer turns on, and the operating system installation starts, then there is a high probability that the cause of the abnormal behavior can be eliminated. And without significant financial costs, which could be required if the computer did not turn on at all.
Blue "death screen" Windows XP (bourgeoisabbreviation - BSOD) is known to every user of operating systems from Microsoft. An unusual name hides a completely predictable behavior of the installer, who discovered an unrecoverable software or hardware error. Very often, this is the case when you install Windows XP. The blue screen at this stage has already become a familiar phenomenon. Interestingly, it is not unique to old configurations. When you install Windows XP, the blue screen can even be displayed by the owner of the most advanced multi-core "combine", despite the fact that all the components work without fail.
In the global network, you can find impressive instructions to identify the causes of this behavior of the operating system. We in this article have collected only those of them that occur most often.
So, one of the most common reasons,because of which when you install Windows XP blue screen - it is an incorrectly configured mode of operation of the disk subsystem. Before you start the installation, it is necessary to go into the BIOS of the motherboard (often pressing the "Del" button immediately after turning on the computer). Then in one of the menu items find the choice of the mode - SATA (AHCI) or IDE (Native) and set the second one.
We do not specify a path to the parameter, since itsThe location depends on the BIOS version and the company that collects motherboards under its name. You should slowly look through all the sections - it must be there. After that, you need to exit the settings while saving the changes and try again to install the system. The IDE mode is fully supported by Windows XP, but there is no AHCI. Exception - assemblies of the operating system with integrated drivers, which can work with any configuration. Important: the system installed and running in the IDE will report a problem - the same blue screen if it is transferred to the AHCI without preliminary programming. The converse is also true.
The next reason is hardware failure inmemory module. It happens that the computer seems to be working, but the failure goes exactly during installation. Solution: it is necessary to take the memory from the motherboard connector one by one and try with the remaining modules. So you can identify the damaged one.
Sometimes the system can not be installed due to the appearance of an unreadable sector on the hard disk. It is necessary to check it for errors. For example, using the program Check Disc.
Finally, a blue screen may appear for a reasonsoftware-hardware conflict. So, if from the moment of the last successful installation new components were connected, then they must be removed and the computer operability checked.